Free Georgia CDL General Knowledge Practice Test 2022

You are looking for an actual Georgia CDL practice test source for your coming CDL test? So you have come to the right place. Our GA General Knowledge Practice Test has the same questions as the real exam which is based on the Georgia CDL manual. Our test covers most of the subject areas on the Georgia General Knowledge Test such as shifting techniques, railroad crossing safety, drunk driving laws, and much more to make you become a safer driver. In addition, each question has a detailed explanation that will help you understand the concept and answer future questions about it correctly. If you don't get the pass right away, don't worry, you can take this practice test an unlimited number of times to make sure you learn all the questions. Our CDL practice test will refine your driving knowledge so you can earn your CDL and start driving on the roads. Let’s get ready to take our practice test now!

Our CDL practice tests:
Based on 2022 GA commercial driver's license manual
Full answers + detailed explanations
Perfect for first-time, renewal applicants
GA CDL General Knowledge Test format:
50 questions
40 correct answers to pass
80% passing score
List of questions
1.
A vehicle is loaded with very little weight on the drive axle. What may happen?
2.
You must drive through deep or flowing water, you should not:
3.
The cargo securement standard applies to commercial vehicles weighing more than:
4.
The North American Cargo Securement Standard cover vehicles weighing:
5.
After taking 10 consecutive hours off duty, a driver begins to work at 8:00 a.m. The driver may operate a commercial motor vehicle until what time?
6.
When using tiedowns to secure boulders, all of the following are requirements except:
7.
There are three maximum limits you must follow at all times. Those limits are:
8.
You are driving a vehicle that could be driven safely at 55 mph on an open road. But traffic is heavy and other vehicles drive at the speed of 35 mph, though the speed limit is 55 mph. The safest speed for your vehicle is more likely to be:
9.
When should drivers inspect their vehicles?
10.
How many knots are acceptable in a properly working tiedown?
11.
On which of the below logs did a violation occur?

Day 1



Day 2

12.
What should you do when you see a hazard in the roadway ahead of you?
13.
What is true about using a heater?
14.
Freeway exits can be dangerous for commercial vehicles, at what speed should you enter the exit?
15.
Which of the following are not a primary factor affecting weight distribution across the axles?
16.
Sliding the 5th wheel will change the weight distribution almost exclusively between which sets of axles?
17.
To prevent brake fade you should:
18.
Overweight, oversized loads:
19.
A hazmat endorsement will be denied or canceled if:
20.
Circumstances that would make wheels and rims unsafe include the following except:
21.
Which of these statements about downshifting is true?
22.
In cargo securement, the deck is:
23.
You weigh the truck immediately before and after fueling. Based on the following, determine what percentage of the weight goes to each set of axles:

Before fueling:

steer: 11,100, drives: 32,600, gross: 71,400

After fueling:

steer:11,850, drives: 32,850, gross: 72,400

24.
When stopping behind another vehicle, a safe gap to leave is one that:
25.
Which of these could be considered off duty time?
26.
When driving at night you should use your high beams when oncoming traffic is not within ____ feet?
27.
You are driving a heavy vehicle with a manual transmission. You have to stop the vehicle on the shoulder while driving on an uphill grade. Which of these is a good rule to follow when putting it back in motion up the grade?
28.
What is the total WLL of two 20mm nylon ropes and one 5/8-inch wire rope?
29.
Option #3 for a single metal coil with eyes lengthwise requires:
30.
What is the minimum aggregate WLL of all tiedowns in a group of concrete pipe?
31.
After turning and getting up to speed:
32.
What is a pallet used for?
33.
If you must drive in fog, some considerations include which of the following:
34.
Any CDL holder found to operating a CMV with ANY alcohol in his/her system will be placed out-of-service for a minimum of:
35.
During the Stop/Start maneuver, when stopped, your vehicle:
36.
What is a headboard?
37.
To help stay alert while driving, when should you take breaks?
38.
The distance that you should look ahead of your vehicle while driving is about __ at low speed.
39.
When securing a single metal coil with eye vertical, tiedowns must be arranged according the all of the following except:
40.
Sliding your trailer tandems toward the front or back of the vehicle will primarily change the weight distribution between which sets of axles?
41.
A driver will generally be required to have a DOT medical card in order to drive which of the following:
42.
If a straight vehicle (not trailer or articulation) goes into front-wheel skid, it will:
43.
When securing building materials, how many tiedowns are required for top tier bundles longer than 5 ft?
44.
What is the minimum number of tie-downs to be used on flatbed cargo?
45.
You weigh the truck immediately before and after fueling. Based on the following, determine what percentage of the weight goes to each set of axles.

Before fueling:

steer: 11,450, drives: 33,100, gross: 76,700

After fueling:

steer:11,850, drives: 33,300, gross: 77,300

46.
Which of these is specifically prohibited when securing crushed or flattened vehicles?
47.
Posted heights at overpasses:
48.
The term 'edge protector' refers to:
49.
When securing paper rolls with friction mats as a primary method:
50.
The maximum number of allowable looks and/or pull-ups on any particular exam exercise is: